Precautions for use of microswitch
Editor in charge: Popularity: 0 Published on: August 28, 2015【 large in Small 】
Precautions for use of microswitch
1) When fixing the switch body, use the small screw M2 on the smooth surface with a torque below 0.098N · m. In addition, in order to prevent the screws from loosening, it is recommended to use washers at the same time.
2) Please note that the action body shall not directly exert force on the button or actuator under free state. When using, the force shall be exerted vertically on the button.
3) Action setting after action, with O T. Values above 70 [%] are standard. In case of switch, do not set the action body at the action limit position, so as not to shorten the service life due to the opening/closing and over travel associated with the impact.
2. Change of action characteristics
With regard to the change of action characteristics, even if the change occurs in ± 20 [%] of the specification value of action characteristics, it shall not cause a fault.
3. About welding operation
In case of manual welding, please use the electric temperature with temperature adjustment 320 ℃ max.) Complete the operation within 3 seconds, and pay attention not to apply force on the terminal during the operation.
4. It is recommended to use low power circuit type (Au clad contact) when using under small current and voltage.
